How To Line A Marching Band Field
How to Line a Marching Band Field
The first step in lining a marching band field is to determine the dimensions of the field. You should start with a 4X4 block on the back side of the field. You’ll then measure the distance between the front sideline and the end zone. Then, determine the dimensions of each of these blocks using Pyware. Then, transcribe these numbers into dot books. Use one page for each coordinate and keep notes about changes in direction and step size. Adjust the field line by approximately one-third of the total measurement, or about 7.5 inches.
When selecting the field line, consider where the band members will be practicing. High-use areas can be worn quickly. Repetitive band formations and patterns can wear out the field. Rotate practice locations to avoid this. This will allow each band member to see the yard lines and reduce the chance of repeating patterns. If possible, consider buying an extra marching band field for each location. These can be purchased at your local sporting goods store or at other locations that offer competitive marching.
Once you’ve identified the locations, you can begin the process of lining the field. You can use either a paintbrush or a spray-on marker. A spray-on paint will work just fine. And a color-coordinated tape will be much easier to follow. Flags can also be used to mark your sets. No matter what method you use, practice is the last step in lining a marching field.
If you follow the instructions below, you should be able complete the entire marching bands field in two to three hours. Murphy’s Law is in full swing when it comes to this type of project. Although the goal for beginners is to line the entire field within a few hours, this is not a scientific process. Just keep in mind that if you’re not an experienced marching band field liner, you’re more likely to make mistakes than succeed.
Knowing what equipment and instruments are needed is another aspect of lining a marching bands field. In addition to the traditional brass instruments, marching bands may use electronic instruments. Electric guitars, for example, are becoming more popular. A keyboard, a bass guitar, and a lead guitarist are all possible marching band instruments. Most electric instruments require external power. This could be a car battery, a small gasoline generator, or a small generator.
After you have decided on the music and instrumentation, the next step will be to plan how to line up a marching band field. Next, you will need to decide which marching band command you want to give to the band to make their transitions easier. A good example of a marching command for the band is the to-the-rear command. The drum major should shout “hut” or “march”, and the members of the marching band should then turn around and place their hands at eye level.